Function to be activated via VCDS - VAG-COM software
Description of the option:
Allows you to recalibrate the reference height of the piloted suspension to the original values.
Audi A8 (4E): standard suspension 416 mm (front) and 398 mm (rear)
Audi A8 (4E): sports suspension 396 mm (front) and 378 mm (rear)
The gear selector must be in neutral (manual gearbox) / in the “P” position (automatic gearbox)
Start the engine, it must run for the duration of the calibration, do not switch off the ignition
All doors must be closed, and not opened during calibration
Actual height measurement of suspensions
It is necessary to measure and record the actual height of each suspension.
The suspension height is the vertical distance between the middle of the wheel and the lower edge of the fender at the wheel arch.
Calibration
[34 – Correct. plate] -> [Security Access – 16] 31564
[34 – Correct. plate] -> [Security Access – 16] 31564 -> [Adaptation – 10] -> Channel 01
Left front suspension adjustment
Enter the previously measured value
[34 – Correct. plate] -> [Security Access – 16] 31564 -> [Adaptation – 10] -> Channel 02
Right front suspension adjustment
Enter the previously measured value
[34 – Correct. plate] -> [Security Access – 16] 31564 -> [Adaptation – 10] -> Channel 03
Left rear suspension adjustment
Enter the previously measured value
[34 – Correct. plate] -> [Security Access – 16] 31564 -> [Adaptation – 10] -> Channel 04
Right rear suspension adjustment
Enter the previously measured value
[34 – Correct. plate] -> [Security Access – 16] 31564 -> [Adaptation – 10] -> Channel 05
Put the value 1
